Range Rover Evoque: Automatic Transmission/Transaxle - Vehicles With: AWF21 6-Speed Automatic Transmission
Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Automatic Transmission & Transaxle / Automatic Transmission/Transaxle - Vehicles With: AWF21 6-Speed Automatic
Transmission
- Transmission Description - Component Location
- Transmission Description - System Operation and Component Description
- Transmission Fluid Level Check
- Transmission Fluid Drain and Refill
- Transmission Control Module (TCM) GTDi 2.0L Petrol
- Torque Converter Seal GTDi 2.0L Petrol
- Transmission GTDi 2.0L Petrol - Removal
- Transmission GTDi 2.0L Petrol - Installation
- Transmission Control Module (TCM) TD4 2.2L Diesel
- Torque Converter Seal TD4 2.2L Diesel
- Transmission Fluid Pan TD4 2.2L Diesel
- Transmission TD4 2.2L Diesel - Removal
- Transmission TD4 2.2L Diesel - Installation
- Transmission Fluid Pan GTDi 2.0L Petrol
READ NEXT:
Transmission Description - Component Location
Component Location
COMPONENT LOCATION
Auxiliary battery module
Transmission Control Switch (TCS)
Upshift (+) paddle switch
Downshift (-) paddle switch
Transmission and Gear Shift Module (GSM) b
Transmission Description - System Operation
and Component Description
Control Diagram
NOTE: A = Hardwired; D = High Speed Controller Area Network (CAN) bus; O =
Local Interconnect Network ( LIN)
Battery
Battery Junction Box (BJB)
Engine Control Module (ECM)
Centr
Torque Converter, Valve Block
TORQUE CONVERTER
Torque converter housing
Lock-up clutch
Turbine
Impeller
Stator
Fluid pump
Input shaft
The torque converter is the coupling element between the engine and the
transmission
SEE MORE:
Driver Seat Cushion Vehicles With: Sports Seats
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables,
Specifications).
2. Make the SRS system safe.
Refer to: Standard Workshop Practices (100-00 General In
Fender Apron Lower Panel
Removal
NOTES:
The fender apron lower panel is manufactured from mild steel.
The panel is serviced less its weld studs
This method describes the LH fender apron lower panel, the RH side is similar.
1. The fender apron lower panel is replaced in conjunction with:
Front bumper cover
Front bumper
© 2011-2025 Copyright www.rrevoque.org
