Range Rover Evoque: Automatic Transmission/Transaxle - Vehicles With: AWF21 6-Speed Automatic Transmission
Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Automatic Transmission & Transaxle / Automatic Transmission/Transaxle - Vehicles With: AWF21 6-Speed Automatic
Transmission
- Transmission Description - Component Location
- Transmission Description - System Operation and Component Description
- Transmission Fluid Level Check
- Transmission Fluid Drain and Refill
- Transmission Control Module (TCM) GTDi 2.0L Petrol
- Torque Converter Seal GTDi 2.0L Petrol
- Transmission GTDi 2.0L Petrol - Removal
- Transmission GTDi 2.0L Petrol - Installation
- Transmission Control Module (TCM) TD4 2.2L Diesel
- Torque Converter Seal TD4 2.2L Diesel
- Transmission Fluid Pan TD4 2.2L Diesel
- Transmission TD4 2.2L Diesel - Removal
- Transmission TD4 2.2L Diesel - Installation
- Transmission Fluid Pan GTDi 2.0L Petrol
READ NEXT:
Transmission Description - Component Location
Component Location
COMPONENT LOCATION
Auxiliary battery module
Transmission Control Switch (TCS)
Upshift (+) paddle switch
Downshift (-) paddle switch
Transmission and Gear Shift Module (GSM) b
Transmission Description - System Operation
and Component Description
Control Diagram
NOTE: A = Hardwired; D = High Speed Controller Area Network (CAN) bus; O =
Local Interconnect Network ( LIN)
Battery
Battery Junction Box (BJB)
Engine Control Module (ECM)
Centr
Torque Converter, Valve Block
TORQUE CONVERTER
Torque converter housing
Lock-up clutch
Turbine
Impeller
Stator
Fluid pump
Input shaft
The torque converter is the coupling element between the engine and the
transmission
SEE MORE:
Changing the smart key batttery
When the battery needs renewing, there will be
a significant decrease in the effective range and
the message SMART KEY BATTERY LOW will
be displayed in the message centre.
To renew the battery:
1. Slide open the side cover.
2. Remove the emergency key and fit into the
receiver.
3. With the
Electrical Precautions
General
The following guidelines are intended to make sure the safety of the operator
whilst preventing damage to the electrical
and electronic components of this vehicle.
Equipment
Prior to commencing any test procedure on the vehicle, make sure that the
relevant test equipment is working correct
© 2011-2025 Copyright www.rrevoque.org
