Range Rover Evoque: Sensor care
When washing the vehicle do
not aim
high pressure water jets directly at the
sensors. Do not use abrasive materials
or hard/sharp objects to clean the
sensors. Only use approved vehicle
shampoo.
The sensors should be kept clean to maintain accuracy and performance.
READ NEXT:
Touch screen overview
Note: Physical controls are referred to as hard
keys. Virtual buttons on the touch screen are
referred to as soft keys.
Screen options will vary depending on vehicle
specification and set-up.
T
Using the touch screen
Always run the engine during
prolonged
use of the touch screen. Failure to do so
may discharge the vehicle battery,
preventing the engine from starting.
Avoid spilling or splashing liquids onto
SEE MORE:
Front End Body Panels
Torque Specifications
Fender
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Refer to: Front Bumper Cover (501-19 Bumpers, Removal and
Installation).
2. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
3.
4.
5.
6. Torqu
Rear Side Member Upper Side Extension
Removal
NOTES:
The rear side member upper side extension is manufactured from mild steel.
If a new Rear side member upper side extension is being replaced in combination
with a rear side member closing
panel some MIG plug welds can be substituted for spot welds on installation
within this procedu
© 2011-2025 Copyright www.rrevoque.org
