Range Rover Evoque: Releasing locking wheel nuts
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Wheel changing / Releasing locking wheel nuts
1. Insert the wheel nut adapter into the locking wheel nut, ensuring that it is fully engaged.
2. Locate the wheel brace over the adapter and unscrew the wheel nut half a turn counter clockwise.
3. After raising the vehicle on the jack, remove the locking wheel nut.
Note: After use store the wheel nut adapter correctly in the tool kit.
READ NEXT:
Wheel changing
WARNING - THAT NO PERSON
SHOULD PLACE ANY PORTION OF
THEIR BODY UNDER A VEHICLE THAT
IS SUPPORTED BY A JACK.
Position the jack from the side of the
vehicle, in line with the appropriate
jacking
Tyre care
Do not drive the vehicle if a
tyre is
damaged, excessively worn, or
incorrectly inflated.
Avoid contaminating the tyres with
vehicle fluids as they may cause
damage to the tyre.
Avoid spinnin
SEE MORE:
Fuel Rail
Special Tool(s)
310-198
Installer, Teflon Seal
310-199
Re-shape Tool, Teflon Seal
Removal
CAUTION: Make sure that all openings are sealed. Use new blanking caps.
NOTE: Some variation in the illustrations may occur, but the essential
information is always correct.
1. Disconnect the battery ground c
Torque Converter Seal TD4 2.2L Diesel
Special Tool(s)
307-597
Installer, Torque Converter Seal
307-613
Holding Pins, Torque Converter
Removal
NOTE: Some variation in the illustrations may occur, but the essential
information is always correct.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
© 2011-2025 Copyright www.rrevoque.org
