Range Rover Evoque: Powered tailgate operation
1. Press to open the powered tailgate.
2. Press and release to close the powered tailgate.
After the tailgate has opened to its set height, it can be manually raised or lowered. If the tailgate fails to open or close correctly, close it manually then press the tailgate release switch again.
As the closing tailgate reaches its lowest position, it will ‘soft close’ to the fully closed position. If the vehicle was previously locked, all doors will re-lock automatically to the previous locked state and the alarm will re-arm.The hazard warning lamps will flash to confirm the lock status. An audible confirmation may also be given.
Note: If a tailgate switch is pressed while the tailgate is opening or closing, all movement will stop. However, if a switch is pressed during the ‘soft close’ stage, the open request will be ignored.
Before operating the
tailgate, ensure
that anyone in the vicinity does not
have any part of their body in a
position where it could be trapped.
Note that the ‘soft close’ action does
not incorporate object detection.
Death or serious injury could occur,
even with an object detection system.
Object detection while opening: If an object is detected that would interfere with the tailgate opening, tailgate movement will stop. Remove any obstructions and press the tailgate switch again to open.
Object detection while closing: If an object is detected that would interfere with the tailgate closing, tailgate movement will stop and then reverse a short distance. An audible warning will be given to indicate a mislock. Remove any obstructions and press the tailgate switch again to close.
While the tailgate is open,
the locking
platform and latch are exposed. Do not
manually close the latch as it may also
automatically ‘soft close’ and trap items
or body parts.
READ NEXT:
Powered tailgate opening height
The maximum opening height can be set as
required. This is useful in parking areas with
low ceiling heights or just for ease of use.
1. Open the tailgate to the position which you
want to set as t
Programmed position loss
The powered tailgate may lose its position
memory if there are multiple object detections
or if battery voltage is low. Powered operation
may be inhibited. To reset the tailgate;
1. Manually close
Changing the smart key batttery
When the battery needs renewing, there will be
a significant decrease in the effective range and
the message SMART KEY BATTERY LOW will
be displayed in the message centre.
To renew the battery:
SEE MORE:
Electronic Engine Controls
Principles of Operation
For a detailed description of the 2.0L GTDi petrol electronic engine
controls, refer to the relevant Description and Operation
section in the workshop manual. REFER to: (303-14B Electronic Engine Controls -
GTDi 2.0L Petrol)
Inspection and Verification
CAUTION: Diagnosis by
Phonebook
Contacts stored in the memory of a paired
phone can be automatically downloaded to the
vehicle’s phonebook each time the phone is
connected to the system. See 141,
TELEPHONE COMPATIBILITY.
Certain mobile phones store the phonebook in
two different areas, the SIM card and the phone
memory. T
