Range Rover Evoque: Fuel filler

all When refuelling ensure that all windows, doors, and sunroof are fully closed, particularly if young children or animals are in the vehicle.
Do not attempt to fill the tank to its maximum capacity. If the vehicle is to be parked on a slope, in direct sunlight, or high ambient temperature, expansion of the fuel could cause spillage.
Do not operate the auxiliary heater when refuelling the vehicle. Doing so may cause fuel vapours to combust causing a fire/explosion.

information Check the fuel pump information carefully, to ensure that you are putting the correct fuel into the vehicle.
If the vehicle is filled with incorrect fuel it is essential that you seek qualified assistance before you start the engine.

Filling station pumps are equipped with automatic cut-off sensing to avoid fuel spillage.

Fill the tank slowly until the filler nozzle automatically cuts-off the supply. Do not attempt to fill the tank beyond this point.

Note: Filling station pumps used for diesel commercial vehicles deliver fuel at a higher rate than normal. The higher fill rate can cause premature cut-off and may cause fuel spillage.
Therefore, it is recommended that only standard light vehicle pumps are used.

READ NEXT:

 Diesel misfuelling protection device

When the misfuelling device is activated, it may cause fuel to be discharged from the filler neck. Note: It is the driver’s responsibility to fill the vehicle with the correct fuel. The diesel

 Fuel tank capacity

Avoid the risk of running out of fuel and never intentionally drive the vehicle when the fuel gauge indicates that the tank is empty. When refuelling your vehicle after the fuel gauge reads empty,

 Fuel specification

Diesel vehicles in Algeria, Egypt, Libya, Morocco, India, Pakistan and Tunisia must only use premium diesel fuel.

SEE MORE:

 Locks, Latches and Entry Systems

Principle of Operation For a detailed description of the locks, latches and entry systems and operation, refer to the relevant Description and Operation section of the workshop manual REFER to: Handles, Locks, Latches and Entry Systems (501-14 Handles, Locks, Latches and Entry Systems, Description

 Balance Shaft Assembly

Special Tool(s) JLR-303-1595 Alignment Tool, Crankshaft Damper Removal NOTES: Some illustrations may show the engine removed for clarity. Some variation in the illustrations may occur, but the essential information is always correct. Removal steps in this procedure may contain installation detail

© 2011-2024 Copyright www.rrevoque.org