Range Rover Evoque: Door lock and release levers
Door lock and release levers
1. Press a locking lever to lock a door. Pull the
lever back to unlock. Operating either front
door locking levers will lock or unlock all
doors.
2. Pull a release lever to open a front door.
To unlock and open a rear door, first
operate the lock lever, then pull the release
lever.
3. Press the master unlock button to unlock
all doors and tailgate.
4. With all doors closed, press the master
lock button to lock all doors and tailgate.
Note: If the vehicle was locked with the Smart
Key, operating an interior door release lever
will unlock only that door. If the door is opened
the alarm will sound.
Note: If the vehicle has been double locked, the
interior door release levers will not operate.
The vehicle must be unlocked using the Smart
Key.
READ NEXT:
Manual seats
Do not adjust
the seat while the
vehicle is moving. Doing so could
cause loss of vehicle control and
personal injury.
1. Forward and back adjustment.
2. Height adjustment.
3.
Electric seats
1. Lumbar support adjustment.
2. Backrest adjustment.
3. Head restraint adjustment.
4. Height adjustment.
5. Forward and back adjustment.
6. Cushion angle adjustment.
To adjust
SEE MORE:
Special Tool(s)
303-1565
Locking Tool, Camshaft
308-511
Installer, Transmission Output Shaft Seal
JLR-303-1594
Locking Tool, Driveplate
JLR-303-748
Locking Tool, Crankshaft
Activation
1.
2. Install the special tool.
Special Tool(s): JLR-303-748
3. Rotate the engine clockwise until the crankshaft
Removal
WARNINGS:
Make sure the spring compressor Safe Working Load (SWL) meets or exceeds
the spring rating quoted in the
Specifcations section.
Always follow the spring compressor manufacturer's instructions.
The spring is under extreme tension, care must be taken at all times. Failure to
foll
© 2011-2024 Copyright www.rrevoque.org