Range Rover Evoque: Instrument Panel GTDi 2.0L Petrol
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Make the SRS system safe.
Refer to: Standard Workshop Practices (100-00 General Information, Description and Operation).
2. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).
3. NOTE: The procedure must be carried out on both sides. Refer to: Cowl Side Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
4. Refer to: Steering Column (211-04 Steering Column, Removal and Installation).
5. Refer to: Windshield Wiper Motor (501-16 Wipers and Washers, Removal and Installation).
6. Refer to: Thermostatic Expansion Valve - GTDi 2.0L Petrol (412-01 Climate Control, Removal and Installation).
7. NOTE: The procedure must be carried out on both sides. Refer to: Front Door (501-03 Body Closures, Removal and Installation).
8. Refer to: Glove Compartment (501-12 Instrument Panel and Console, Removal and Installation).
9. Refer to: Front Seat (501-10 Seating, Removal and Installation).
10. Refer to: Floor Console (501-12 Instrument Panel and Console, Removal and Installation).
11. NOTE: The step must be carried out on both sides.
Torque: 6 Nm
12. NOTE: The step must be carried out on both sides.
13.
14.
15.
16.
17.
18.
19.
20.
21.
22.
23.
24. CAUTION: Make sure that all openings are sealed.
Use new blanking caps.
Clamp the hoses to minimize coolant loss.
25. Torque: 40 Nm
26. Torque: 24 Nm
27. NOTES:
Right-hand shown, left-hand similar.
The step must be carried out on both sides.
Torque: 24 Nm
28. NOTES:
Right-hand shown, left-hand similar.
The step must be carried out on both sides.
Torque: 40 Nm
29. CAUTION: Protect the surrounding trim to avoid damage.
NOTE: With assistance remove the component.
Torque: 24 Nm
Installation
1. To install, reverse the removal procedure.
2. Check and top-up the coolant if required.
READ NEXT:
Instrument Panel Upper Section
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables,
Specifications).
Floor Console
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Refer to: Floor Console Upper Section (501-12 Instrument Panel and
Console, Removal and Installation).
2. NOTES:
The
Overhead Console
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. CAUTION: Take extra care not to damage the
edges of the component.
2.
3. NOTE: Do not disassemble further if the
co
SEE MORE:
Side Air Bag Module Vehicles With: Sports
Seats
Removal
WARNINGS:
To avoid accidental deployment and possible personal injury, the backup
power supply must be depleted before
repairing or replacing any air bag supplemental restraint system (SRS)
components. To deplete the backup power supply
energy, disconnect the battery ground cable and wait
Bolt and Nut Identification
An ISO metric bolt or screw made of steel and larger than 6 mm in diameter
can be identified by either of the symbols ISO
M or M embossed or indented on top of the bolt head.
In addition to marks identifying the manufacturer, the top of the bolt head
is also marked with symbols indicating the
st
