Range Rover Evoque: Engine starting: automatic transmission
1. A valid Smart Key must be inside the
vehicle.
2. Make sure the gear selector is in P or N.
3. Firmly depress the brake pedal.
4. Press and release the start button. The
engine will crank automatically until it
starts. For diesel engined vehicles there
may be a delay while the glow plugs warm
up, then the engine will crank automatically
until it starts.
READ NEXT:
Note: Do not press the accelerator pedal when
starting the engine.
1. A valid Smart Key must be inside the
vehicle.
2. Fully depress the clutch pedal.
3. Press and release the start button. For
Note: If the engine fails to crank when the
START/STOP button is pressed and there has
been a recent collision, seek qualified
assistance.
If the engine fails to crank, or fails to start,
consult
Before switching off the engine, ensure that the
vehicle is parked safely with the park brake
applied.
1. Select P for automatic transmission, or
neutral for manual transmissions.
Note: If any ot
SEE MORE:
CAUTION:
Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution
of control modules does
not guarantee confirmation of a fault, and may also cause additional faults in
the vehicle being tested and/or the donor
vehicle
NOTES:
If the control module or a component is suspect
Engine Upper Support Insulator
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is
always correct.
1. Refer to: Engine Mount RH (303-01B Engine - GTDi 2.0L Petrol,
Removal and Installation)
© 2011-2024 Copyright www.rrevoque.org