Range Rover Evoque: If the engine fails to start
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Starting the engine / If the engine fails to start
Note: If the engine fails to crank when the START/STOP button is pressed and there has been a recent collision, seek qualified assistance.
If the engine fails to crank, or fails to start, consult your Dealer/Authorised Repairer.
Diesel engines:
If the engine persistently fails to start, make sure the transmission is in P or N (neutral for manual transmission vehicles) then press the START/STOP button (with the brake pedal applied). Keep the START/STOP button and the brake pedal pressed until the engine starts, then release.
If the engine still fails to crank, or fails to start consult your Dealer/Authorised Repairer.
READ NEXT:
Switching off the engine
Before switching off the engine, ensure that the
vehicle is parked safely with the park brake
applied.
1. Select P for automatic transmission, or
neutral for manual transmissions.
Note: If any ot
Switching off the engine with the vehicle moving
It is not advisable to switch
off the
engine while the vehicle is moving.
However, should such a situation
arise, then the following procedure
applies.
- Press and hold the engine START/STOP
Rolling re-start
If the engine is switched off while the vehicle is
moving, a rolling re-start can be initiated.
Automatic transmission - select neutral (N) and
then press the engine START/STOP button.
When the en
SEE MORE:
Control Diagram, System Operation
Control Diagram
NOTE: A = Hardwired; D = High Speed CAN (controller area network) bus; N =
Medium Speed CAN bus; O = LIN
(local interconnect network) bus
DW12C is shown, GTDi is similar
Battery
Blower motor
LH (left-hand) temperature blend stepper motor
Windshield distribution (defrost) stepp
Balance Shaft Assembly
Special Tool(s)
JLR-303-1595
Alignment Tool, Crankshaft Damper
Removal
NOTES:
Some illustrations may show the engine removed for clarity.
Some variation in the illustrations may occur, but the essential information is
always correct.
Removal steps in this procedure may contain installation detail
© 2011-2024 Copyright www.rrevoque.org
