Range Rover Evoque: Airbag service information
Do not attempt to service,
repair,
replace, modify, or tamper with, any
part of the SRS. This includes wiring
or components in the vicinity of SRS
components. Doing so may cause the
system to trigger, or render the
system inoperative.
Do not use any electrical test
equipment or devices in the vicinity of
SRS components or wiring. Doing so
may cause the system to trigger, or
render the system inoperative.
All of the following operations should be
carried out only by a Dealer/Authorised
Repairer, or suitably qualified person:
- Removal or repair of any wiring or
component in the vicinity of any SRS
components.
- Installation of electrical, or electronic, equipment and accessories.
- Modification to the front or sides of the vehicle exterior.
- Attachment of accessories to the front or sides of the vehicle.
READ NEXT:
Disability modifications
Occupants with disabilities which may require
modification of the vehicle, must contact a
Dealer/Authorised Repairer before any
modifications are made.
Lighting control
Lighting control
1. With the headlamps on, push the control
away from the steering wheel to select high
beam. The instrument pack warning lamp
will illuminate.
Note: Do not use high beam where
SEE MORE:
Using the touch screen
Always run the engine during
prolonged
use of the touch screen. Failure to do so
may discharge the vehicle battery,
preventing the engine from starting.
Avoid spilling or splashing liquids onto
the touch screen.
Switching on
- Switch on the ignition.
- Switch on the touch screen.
The mos
Instrument Panel Upper Section
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables,
Specifications).
2. Make the SRS system safe.
Refer to: Standard Workshop Practices (100-00 General Information,
De
