Range Rover Evoque: Trailer hitch - australia only

When selecting a drawbar for the receiver, the following dimensions must be adhered to:

A. The maximum recommended drawbar

A. The maximum recommended drawbar length is 178mm (7 in).

B. To achieve the maximum ball height, a drawbar with a rise of 68mm (2.7 in) is recommended.

Consult your Land Rover Dealer/Authorised Repairer for the latest information.

READ NEXT:

 Tow bar dimensions

Tow bar dimensions

 Starting the engine

 Switching on the ignition

To turn on the ignition without starting the engine: - Do not depress the brake/clutch pedal, - Press the START/STOP button and hold until the warning lamps illuminate, then release the button.

SEE MORE:

 Drive Pinion Front Bearing

Special Tool(s) 100-012 Slide Hammer 205-067 Preload Gauge 308-615 Remover, Seals JLR-205-972 Mounting Bracket, Rear Axle JLR-205-984 Remover/Installer, Drive Pinion Nut JLR-205-985 Remover, Drive Pinion Bearing JLR-205-986 Installer, Drive Pinion Bearing Removal 1. Raise and support the vehicle. 2.

 Liftgate Alignment, Front Door

Liftgate Alignment NOTE: Some variation in the illustrations may occur, but the essential information is always correct. 1. With the liftgate closed, check the alignment of the liftgate to the roof panel and bodyside panel. The liftgate should be central in its aperture. 2. Refer to: Rear Spoiler

© 2011-2024 Copyright www.rrevoque.org