Range Rover Evoque: Smart key check
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Entering the vehicle / Smart key check
If the ignition is on or the engine is running and there is no Smart Key inside the vehicle when the last door is closed, the message Smart Key Not Found Refer to Handbook will be displayed in the message centre.
Ensure that the Smart Key is in the
vehicle before it is driven to another
location. Without the Smart Key, if the
ignition is turned off, it cannot be turned
on again.
If only the ignition is on and the Smart Key is removed from the vehicle and the driver’s door is the last to be closed, the ignition will switch off.
Note: The engine cannot be started without the Smart Key in the vehicle.
READ NEXT:
Disarming if the smart key and keyless entry fail to work
The vehicle can still be unlocked and the alarm
disabled. To unlock the vehicle:
1. Unlock the left side front door using the
key blade. The alarm will be triggered.
2. Position the Smart Key agai
Deactivating the alarm when triggered
If the alarm has been triggered, it can be
deactivated by any one of the following
methods:
- Pressing the unlock button on the Smart
Key.
- Opening a door using keyless entry.
- Positioning a v
Smart key system transmitters
Any person fitted with an
implanted
medical device should ensure that the
device is kept at a distance of at least
22 cm (8.7 inches) away from any
transmitter mounted in the vehicle.
This is
SEE MORE:
Checking the tyre pressure after a repair
When driving the vehicle, if
you
experience vibrations, abnormal
steering, or noises, reduce speed
immediately. Drive with extreme
caution and reduced speed to the first
safe place to stop the vehicle. Visually
examine the tyre, and check its
pressure. If there are any signs of
damage or
Checking the tyre pressures
Tyre information label location.
Tyre pressures should be
checked
regularly using an accurate pressure
gauge, when the tyres are cold.
The following procedure should be used to
check and adjust the tyres pressures.
1. Remove the valve cap.
2. Firmly attach a tyre pressure gauge/inflator
© 2011-2024 Copyright www.rrevoque.org
