Range Rover Evoque: Removing the temporary spare wheel

to Remove the spare wheel prior to jacking the vehicle, to avoid destabilising the vehicle when raised.

loosen the Do not use power tools to loosen the spare wheel. Doing so may damage the mechanism.

1. To access the temporary spare wheel, fold forward the rear edge of the cover then remove it.

2. Turn the temporary spare wheel locking ring counter clockwise to gain access to the retaining bolt.

3. Turn the retaining bolt counter clockwise until it comes free.

4. Remove the temporary spare wheel.

READ NEXT:

 Temporary spare wheel

Always adhere to the instructions given on the temporary use spare wheel warning label. Failure to comply can be dangerous. When a temporary use spare wheel is fitted, drive with caution and r

 Using wheel chocks

Note: Wheel chocks are not supplied as part of the tool kit. Wheel chocks are a useful addition to a vehicle tool kit. Note the following advice when using wheel chocks. Before raising the vehic

 Wheel changing safety

Before raising the vehicle or changing a wheel, ensure that you read and comply with the following warnings. Always find a safe place to stop, off the highway and away from traffic. Ensure tha

SEE MORE:

 Engine Wiring Harness TD4 2.2L Diesel, Vehicles With: AWF21 6-Speed Automatic Transmission

Removal CAUTIONS: Make sure that the wiring harness is not twisted or damaged on removal. Failure to follow this instruction may result in damage to the vehicle. Take extra care not to damage the wiring harness clips. NOTES: Some variation in the illustrations may occur, but the essential informa

 Headlamps

Moving the nearside headlamp unit to access bulbs; 1. Remove the two plastic fixings. 2. Pull the tube up to release from the air box. This will allow more room for manoeuvrability. 3. Remove the four grille fixings. 4. Remove the two retaining bolts. 5. At the rear of the headlamp unit, p

© 2011-2025 Copyright www.rrevoque.org