Range Rover Evoque: Transfer Case Rear Seal
Special Tool(s)
100-012
Slide Hammer
205-871
Installer, Transfer Case Rear Seal
308-615
Remover, Seals
308-617
Depth Drill, Seal Remover
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is always correct.
All vehicles
1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.
Vehicles with diesel particulate filter (DPF)
2.
All vehicles
3. CAUTIONS: Mark the position of the driveshaft flange in relation to the drive pinion flange.
To avoid damage to the joint or gaiter, do not allow the driveshaft to hang.
Make sure that the driveshaft is supported with suitable retaining straps.
Torque: 40 Nm
4. CAUTION: Make sure that a new bolt is installed.
NOTE: Position cloth to collect fluid spillage.
Torque: 48 Nm
5.
- Special Tool(s): 308-617
6. CAUTIONS: Make sure that the area around the component is clean and free of foreign material.
Take extra care not to damage the mating faces.
- Special Tool(s): 308-615
- Special Tool(s): 100-012
Installation
1.
- Special Tool(s): 205-871
2. To install, reverse the removal procedure.
3. Check and top-up the transfer case fluid level.
Refer to: Transfer Case Fluid Level Check (308-07B Transfer Case - Vehicles With: AWF21 6-Speed Automatic Transmission/M66 6-Speed Manual Transmission AWD, General Procedures).
