Range Rover Evoque: Power Transfer Unit TD4 2.2L Diesel

Removal

NOTE: Removal steps in this procedure may contain installation details.

All vehicles

1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.

2. Refer to: Front Halfshaft RH - LHD AWD/RHD AWD (205-04 Front Drive Halfshafts, Removal and Installation).

3. Refer to: Engine Undershield (501-02 Front End Body Panels, Removal and Installation).

4. Torque:

Range Rover Evoque. Transfer Case - Vehicles With: AWF21 6-Speed Automatic
Transmission/M66 6-Speed Manual Transmission AWD

5. Torque:

Range Rover Evoque. Transfer Case - Vehicles With: AWF21 6-Speed Automatic
Transmission/M66 6-Speed Manual Transmission AWD

Vehicles with diesel particulate filter (DPF)

6.

Range Rover Evoque. Transfer Case - Vehicles With: AWF21 6-Speed Automatic
Transmission/M66 6-Speed Manual Transmission AWD

All vehicles

7. CAUTIONS: Mark the position of the driveshaft flange in relation to the drive pinion flange.

To avoid damage to the joint or gaiter, do not allow the driveshaft to hang.

To avoid damage to the joint or gaiter, do not allow the driveshaft to hang.

Torque: 40 Nm

Range Rover Evoque. Transfer Case - Vehicles With: AWF21 6-Speed Automatic
Transmission/M66 6-Speed Manual Transmission AWD

8. CAUTIONS: Discard the bolt.

Make sure that a new bolt is installed.

Torque:

READ NEXT:

 Transfer Case Connecting Sleeve Seals GTDi 2.0L Petrol

Special Tool(s) 100-012 Slide Hammer 307-594 Installer, Seal 308-005 Remover, Axle oil seal Removal NOTE: Some variation in the illustrations may occur, but the essential information is always correc

 Transfer Case Connecting Sleeve Seals TD4 2.2L Diesel, Vehicles With: AWF21 6-Speed Automatic Transmission

Special Tool(s) 100-012 Slide Hammer 307-594 Installer, Seal 308-005 Remover, Axle oil seal Removal NOTE: Some variation in the illustrations may occur, but the essential information is always correc

 Transfer Case Connecting Sleeve Seals TD4 2.2L Diesel, Vehicles With: M66 6-Speed Manual Transmission AWD

Special Tool(s) 100-012 Slide Hammer 303-1300 Remover, Crankshaft Seal 303-538 Remover/Installer, Crankshaft Oil Seal 307-594 Installer, Seal 307-595 Installer, Intermediate Shaft Seal 308-615 Remover

SEE MORE:

 Fuel Pump

Removal WARNING: This procedure involves fuel handling. Be prepared for fuel spillage at all times and always observe fuel handling precautions. Failure to follow these instructions may result in personal injury. NOTE: Removal steps in this procedure may contain installation details. 1. Disconnect

 Headlamps

Moving the nearside headlamp unit to access bulbs; 1. Remove the two plastic fixings. 2. Pull the tube up to release from the air box. This will allow more room for manoeuvrability. 3. Remove the four grille fixings. 4. Remove the two retaining bolts. 5. At the rear of the headlamp unit, p

© 2011-2025 Copyright www.rrevoque.org