Range Rover Evoque: Pairing and connecting from the touch screen
1. Switch on your mobile phone’s Bluetooth®
connection. Make sure that your mobile
phone is in Bluetooth® discoverable mode,
sometimes referred to as find me mode
(see your phone’s operating instructions
for more information).
2. Switch the ignition on and ensure that the
touch screen is active.
3. From the home menu select Phone.
4. A menu will appear. Select Search new.
5. Select Vehicle to device option.
6. Identify your phone from the displayed list
and select the corresponding Pair and
connect option.
Note: If more than 5 devices are detected,
it may be necessary to use the scroll bar to
see the entire list.
7. When prompted, enter the PIN code into
your phone. See your phone’s operating
instructions for further information.
8. Once your phone is paired and connected
to the system, a confirmation message will
be displayed before switching to the Digit
Dial screen.
Note: Due to the duration of a Bluetooth®
search, it is advised that the timeout to home
screen feature is switched off before
attempting to search for Bluetooth® devices.
This setting can be changed within Vehicle,
Syst settings, Display set, Timeout to home
screen.
READ NEXT:
Up to 10 mobile phones can be paired with the
vehicle in the same way. However, only one can
be connected and ready for use as a phone at
any one time.
To connect a different paired phone, follow
Connect. Use to send or accept
a call and access last 10 dialled
numbers.
Disconnect. Use to end or reject
a call.
No phone connected.
Phone signal strength indicator.
Phone battery l
Connect. Press and release to
send or accept a call or to
access the last 10 dialled list.
Press and hold to access the
phonebook.
Disconnect. Use to end or reject
a call.
Voice control t
SEE MORE:
Removal
CAUTIONS:
If a new component is to be installed, the Land Rover approved diagnostic
equipment must be connected prior to
removal, the data must then be downloaded from it and the keys (remote control
handsets) set into default mode. Failure
to follow this instruction will result in permane
Event data recorders are capable of collecting
and storing short sequences of data during a
crash or near-crash event. The recorded
information may assist in the investigation of
such an event. The EDR may record
information about vehicle dynamics and safety
systems, potentially including such
© 2011-2025 Copyright www.rrevoque.org
