Range Rover Evoque manuals

Range Rover Evoque: Lighting control

Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Exterior lights / Lighting control

Lighting control
Lighting control

1. With the headlamps on, push the control away from the steering wheel to select high beam. The instrument pack warning lamp will illuminate.

Note: Do not use high beam where it may distract other road users.

2. Pull the control towards the steering wheel and release to flash the high beam on and off. The high beam will remain on for as long as the switch is held.

3. Sidelights.

4. Headlamps.

5. AUTO. With Auto lamps selected, when ambient light fades and the ignition is on, the side lamps, tail lamps, low beam headlamps and licence plate lamps will switch on automatically. Headlamp courtesy delay, High beam assist and Windscreen wipers detection may also be activated.

Note: Low exterior light levels, caused by adverse weather conditions, may also cause the autolamp system to activate.

6. Rear fog lamps. Will operate only while sidelights, headlamps or Auto lamps are selected. Turn the collar towards the steering wheel and release. The instrument pack warning lamp will illuminate.

7. Front fog lamps. Will operate only while sidelights, headlamps or Auto lamps are selected. Turn the collar away from the steering wheel and release.The instrument pack warning lamp will illuminate.

READ NEXT:

 Daytime running lamps

Daytime running lamps are LED lamps. With the lighting control in the OFF position or in AUTO position while lighting conditions do not require headlamps on, then daytime running lamps will switch

 Headlamp courtesy delay

This feature operates whenever the lamps master switch is in the AUTO (5) position and the ignition is turned off. The headlamps will remain illuminated for up to 240 seconds. Note: The time delay

 High beam assist

This feature of the Xenon lighting automatically selects and deselects high beam, under specific conditions of road lighting and in the absence of other vehicle’s lights. The system is only acti

SEE MORE:

 Roof Panel Vehicles Without: Sliding Roof Opening Panel

Removal NOTES: The roof panel is manufactured from aluminium 6111T4. The screw in studs must be renewed with the installation of a new roof panel. 1. The roof panel is replaced in conjunction with: Liftgate Windshield Headliner 2. For additional information relating to this repair procedure p

 Engine oil specification

It is important that the correct oil specification is used. Vehicles fitted with a diesel particulate filter (DPF) must use the specified oils otherwise significant engine damage will occur. Specified oils ensure that the life of the DPF is maximised. When a new vehicle is sold into markets wh

© 2011-2025 Copyright www.rrevoque.org