Range Rover Evoque: Fuel Filler Door

Removal

CAUTION: Make sure to protect the paintwork.

1.

Range Rover Evoque. Body Closures

Installation

1.

Range Rover Evoque. Body Closures

Fuel Filler Door Assembly

Removal

WARNING: Avoid flames, sparks or lighted substances.

CAUTION: Extreme cleanliness must be exercised when handling these components.

NOTES:

Removal steps in this procedure may contain installation details.

Some variation in the illustrations may occur, but the essential information is always correct.

Make sure that all openings are sealed. Use new blanking caps.

1. Remove the rear wheel.

Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation).

2.

Range Rover Evoque. Body Closures

3.

Range Rover Evoque. Body Closures

4.

Range Rover Evoque. Body Closures

5.

Range Rover Evoque. Body Closures

6.

Range Rover Evoque. Body Closures

7. CAUTION: Make sure to protect the paintwork.

NOTE: Do not disassemble further if the component is removed for access only.

Range Rover Evoque. Body Closures

Installation

1.

Range Rover Evoque. Body Closures

2. To install, reverse the removal procedure.

READ NEXT:

 Body Closures - Component Location, System Operation and Component Description

Component Location Powered Tailgate - Component Location Tailgate module Powered strut Tailgate open button Tailgate close button Latch assembly Powered cinch motor Powered strut OVERVIEW Ta

 Interior Trim and Ornamentation

 A-Pillar Trim Panel, B-Pillar Upper Trim Panel 5-Door

A-Pillar Trim Panel Removal NOTE: Removal steps in this procedure may contain installation details. 1. Torque: 6 Nm Installation 1. To install, reverse the removal procedure. B-Pillar Upper Trim Pane

SEE MORE:

 Engine Cooling - Component Location, System Operation and Component Description

Component Location COMPONENT LOCATION Heater core Air Conditioning (A/C) Evaporator (ref only) Heater inlet hose Heater outlet hose/Oil cooler inlet hose Turbocharger water outlet pipe Water outlet Transmission fluid cooler Electric cooling fan - Left Hand (LH) Radiator top hose By-pass

 Starting System - GTDi 2.0L Petrol

Starting System - Component Location COMPONENT LOCATION Solenoid 12V supply from battery Solenoid power supply from Battery Junction Box (BJB) Starter motor Pinion gear Starting System - Overview OVERVIEW The starter motor is rated as 1.3 kW and is a Denso conventional design with the motor

© 2011-2025 Copyright www.rrevoque.org