Range Rover Evoque: Differential Draining and Filling

1. WARNING: Make sure to support the vehicle with axle stands.

CAUTION: Make sure the vehicle is on a flat level surface.

Raise and support the vehicle.

2. No provision is made to fully drain the rear differential.

During repair procedures, fluid will be lost. A container should be positioned to collect any spillage.

Range Rover Evoque. Rear Drive Axle/Differential

3. Make sure the vehicle is level. Remove the rear differential filler plug and discard the sealing washer.

4. Fill the rear differential, until a thin thread of fluid runs from the filler hole.

Refer to: Specifications (205-02 Rear Drive Axle/Differential, Specifications).

5. Using a new washer, install the drain plug.

Torque: 35 Nm

6. Lower the vehicle.

Active On-Demand Coupling Filling

NOTE: If installing a new active on-demand coupling, fill with 650 ml of fluid. It is not possible to completely drain the active on-demand coupling fluid during service. The procedure below MUST be followed for both filling and topping up.

1. CAUTION: Make sure the vehicle is on a flat level surface. Raise and support the vehicle.

2. No provision is made to fully drain the active on-demand coupling.

During repair procedures, fluid will be lost. A container should be positioned to collect any spillage.

3. CAUTION: This is a filler plug only and must not be used as a fluid level indicator. Make sure the vehicle is level. Remove the filler plug and discard the sealing washer.

Range Rover Evoque. Rear Drive Axle/Differential

4. Fill the active on-demand coupling, until a thin thread of fluid runs from the filler hole.

Refer to: Specifications (205-02 Rear Drive Axle/Differential, Specifications).

5. Install the active on-demand fluid filler plug.

6. Turn the ignition on for 5 minutes.

7. Turn the ignition off and remove the remote handset.

8. Fill the active on-demand coupling, until a thin thread of fluid runs from the filler hole.

9. CAUTION: This is a filler plug only and must not be used as a fluid level indicator. Using a syringe, remove exactly 70 ml of fluid.

10. CAUTION: Replace the washer.

Install and tighten the filler plug.

Torque: 35 Nm

READ NEXT:

 Active On-Demand Coupling Vehicles With: AWF21 6-Speed Automatic Transmission

Removal 1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle. 2. Refer to: Exhaust System (309-00B Exhaust System - TD4 2.2L Diesel, Removal and Installation).

 Active On-Demand Coupling Module

Removal NOTE: If a new Active on-demand coupling module is installed, the throttle valve must also be installed. 1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the v

 Differential Case Vehicles With: AWF21 6-Speed Automatic Transmission

Removal NOTE: Removal steps in this procedure may contain installation details. All vehicles 1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle. 2. Remove th

SEE MORE:

 Air Bag and Safety Belt Pretensioner Supplemental Restraint System (SRS)

Principle of Operation For a detailed description of the supplemental restraints system and operation, refer to the relevant Description and Operation section in the workshop manual. REFER to: (501-20B Supplemental Restraint System) Safety Information WARNINGS: TO AVOID ACCIDENTAL DEPLOYMENT AND P

 Accessing navigation

From the Home menu touch the On road nav soft key. Alternatively press the NAV hard key on the facia. A caution screen will be displayed. If the navigation screen language has not been set, now is the time to set it. Select Language, make a selection and confirm it by touching the OK soft key.

© 2011-2025 Copyright www.rrevoque.org