Range Rover Evoque: B-Pillar Lower Trim Panel, D-Pillar Trim Panel
Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Body and Paint / Interior Trim and Ornamentation / B-Pillar Lower Trim Panel, D-Pillar Trim Panel
B-Pillar Lower Trim Panel
Removal
NOTE: Removal steps in this procedure may contain installation details.
1.
2.
3.
4. CAUTION: Discard the bolt.
Torque: 45 Nm
5.
6.
Installation
1. WARNING: Make sure that a new bolt is installed.
CAUTION: Make sure the safety belt is secure and correctly installed.
NOTE: Make sure the safety belt is operating correctly.
To install, reverse the removal procedure.
D-Pillar Trim Panel
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1.
2. NOTE: LH side only.
3.
5-door
4.
3-door
5.
All vehicles
6. Torque: 6 Nm
7.
8.
Installation
1. To install, reverse the removal procedure.
READ NEXT:
Front Door Trim Panel
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. Torque: 6 Nm
2. Torque: 6 Nm
3. Torque: 0.9 Nm
4. Torque: 1.3 Nm
5-door
5.
3-door
6.
All vehicles
Rear Door Trim Panel
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Torque: 1.3 Nm
2. Torque: 6 Nm
3. Torque: 6 Nm
4.
5.
6.
7. NOTE: Do not disassemble further if the
component is
Headliner
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Vehicles with glass roof panel shown, vehicles without glass roof panel similar.
All vehicles
1. Refer to: Windshield
SEE MORE:
Engine Timing
Special Tool(s)
303-1565
Locking Tool, Camshaft
308-511
Installer, Transmission Output Shaft Seal
JLR-303-1594
Locking Tool, Driveplate
JLR-303-748
Locking Tool, Crankshaft
Activation
1.
2. Install the special tool.
Special Tool(s): JLR-303-748
3. Rotate the engine clockwise until the crankshaft
Inner Quarter Panel
Removal
NOTES:
The inner quarter panel is manufactured from mild steel.
There are NVH components on this panel, they are not serviced on the new panel.
If damaged, new components will be required.
1. The front inner quarter panel is replaced in conjunction with:
Rear bumper cover
Quarter panel
© 2011-2025 Copyright www.rrevoque.org
