Range Rover Evoque: Oil Pump
Removal
NOTES:
Some illustrations may show the engine removed for clarity.
Some variation in the illustrations may occur, but the essential information is always correct.
Removal steps in this procedure may contain installation details.
1. Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).
2. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.
3. Refer to: Timing Cover (303-01B Engine - GTDi 2.0L Petrol, Removal and Installation).
4. Refer to: Air Cleaner (303-12B Intake Air Distribution and Filtering - GTDi 2.0L Petrol, Removal and Installation).
5. Refer to: Air Conditioning (A/C) Compressor - GTDi 2.0L Petrol (412-01 Climate Control, Removal and Installation).
6. Refer to: Engine Oil Draining and Filling (303-01B Engine - GTDi 2.0L Petrol, General Procedures).
7. CAUTION: Using a suitable tool, hold the oil pump gear when removing the centre bolt.
- Torque: 25 Nm
8.
9. Torque: 8 Nm
10. Torque: 25 Nm
11. Torque: 35 Nm
12. Torque: 4 Nm
13.
14. Torque: 10 Nm
15. NOTE: During installation tighten the bolts simultaneously or crosswise.
Torque:
- Stage 1: 10 Nm
- Stage 2: 20 Nm
Installation
1. NOTE: Make sure that all traces of the old sealant are removed from the mating faces. To install, reverse the removal procedure.
2. NOTES: Install a new gasket.
Note - Apply sealant WSE-M4G323-A6 in a 2-3mm diameter on the engine oil sump as shown. The component must be installed and tightened within 10 minutes of sealant application.
3. NOTE: Note - TAS | Engine | Apply sealant WSE-M4G323-A6 in a 2-3mm diameter on the engine front cover as shown. The component must be installed and tightened within 10 minutes of sealant application.
READ NEXT:
Timing Chain
Removal
NOTES:
Some illustrations may show the engine removed for clarity.
Some variation in the illustrations may occur, but the essential information is
always correct.
1. Refer to: Specifications
Timing Cover
Special Tool(s)
303-021
Engine support bracket
JLR-303-1591
Lifting Bracket, Engine - Rear
Removal
NOTES:
Some illustrations may show the engine removed for clarity.
Some variation in the illustratio
Valve Cover
Removal
NOTES:
Some illustrations may show the engine removed for clarity.
Some variation in the illustrations may occur, but the essential information is
always correct.
Removal steps in this proc
SEE MORE:
Differential Draining and Filling
1. WARNING: Make sure to support the vehicle with axle stands.
CAUTION: Make sure the vehicle is on a flat level surface.
Raise and support the vehicle.
2. No provision is made to fully drain the rear differential.
During repair procedures, fluid will be lost. A container
should be positioned to c
Power Flows
Operation of the transmission is controlled by the TCM which electrically
activates various solenoids to control the
transmission gear selection. The sequence of solenoid activation is based on
programmed information in the TCM memory
and physical transmission operating conditions such as vehicle
