Range Rover Evoque: Installing an isofix child seat
Installing an isofix child seat
To install an ISOFIX child seat:
1. Locate the ISOFIX locking mechanism.
2. Slide the child seat into the locking
mechanism.
3. If an upper tether is fitted to the child seat,
ensure it is properly secured to the upper
tether anchorages on the rear of the seats.
Test the security of the child restraint. To do
this, attempt to pull the restraint away from the
vehicle seat and twist the restraint from side to
side. Even if the restraint appears secure, you
should still check the anchor points visually, to
ensure correct attachment.
Note: Always ensure that if an upper tether is
provided, it is fitted and tightened correctly.
READ NEXT:
WARNING:
Child restraint anchorages
are designed to withstand only those
loads imposed by correctly fitted child
restraints. Under no circumstances
are they to be used for adult seat
belts, ha
1. Install the child restraint securely in one of
the rear seating positions.
2. Pass the tether strap over the seat back and
beneath the head restraint.
3. Attach the tether strap hook to the tet
Airbag supplementary restraint system (SRS)
1. Front passenger’s airbag
2. Curtain airbags
3. Side airbags
4. Knee-bolster airbag
5. Driver’s airbag
Note: The general location of airbags f
SEE MORE:
Engine Oil Draining and Filling
Draining
NOTE: Removal steps in this procedure may contain installation details.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Remove the engine undershield.
Refer to: Engine Undershield (501-02 Front End Body Panels
Special Tool(s)
205-857
Remover, Halfshaft
Removal
CAUTIONS:
Nuts and bolts must be tightened with the weight of the vehicle on the
suspension.
Do not allow halfshafts to hang unsupported at one end or joint damage will
occur.
Make sure the halfshaft constant velocity (CV) joints do not over art
© 2011-2024 Copyright www.rrevoque.org