Range Rover Evoque: How it works
Viewing angles for driver and front seat
passenger are such that neither can view the
full display that the other is viewing. However,
there is an optimum viewing angle of 30
degrees where no cross over of images can be
perceived. From this point, the closer to screen
centre or screen side edges that the viewer
moves to, the more likely cross over of images
is. During normal use of dual view, image cross
over is unlikely.
Rear seat passengers may be able to see both
views when dual view is active.
READ NEXT:
When the ignition is switched on or the audio
unit is turned on after being turned off, single
view mode will be the default view.
To select dual view, press the dual view hard
key on the fascia s
Dual view control menu
1. Select to cancel dual view and revert to the
menu for the current video source (TV,
DVD).
Note: The preview screen will be
deactivated if the vehicle is moving.
2. Se
If you would like to change the TV programme
while the vehicle is moving, there are two
methods available;
1. Press the dual view hardkey to display the
control menu.
Select an alternative channe
SEE MORE:
Special Tool(s)
205-857
Remover, Halfshaft
JLR-204-804
Lever, Wheel Knuckle
Removal
CAUTIONS:
Nuts and bolts must be tightened with the weight of the vehicle on the
suspension.
Do not allow halfshafts to hang unsupported at one end or joint damage will
occur.
Make sure the halfshaft constant vel
Connect only approved
electrical
circuits, which are in good condition, to
the trailer socket.
The vehicle connector provides a 5 amp output
which must not be exceeded. An accessory
harness kit increasing output to 15 amp is
available from your Land Rover Dealer.
When a trailer electrica
© 2011-2024 Copyright www.rrevoque.org