Range Rover Evoque: Front Stabilizer Bar AWD
Removal
CAUTION: Nuts and bolts must be tightened with the weight of the vehicle on the suspension.
NOTES:
Only use clean water as a lubricant for the bushing, if required.
Removal steps in this procedure may contain installation details.
1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.
2. Remove the front wheels and tires.
Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation).
3. CAUTION: Make sure that new bolts are installed.
- Torque: 40 Nm
- Using a suitable tie strap, secure the driveshaft.
4. Refer to: Catalytic Converter (309-00A Exhaust System - GTDi 2.0L Petrol, Removal and Installation).
Refer to: Catalytic Converter - Vehicles Without: Diesel Particulate Filter (DPF) (309-00B Exhaust System - TD4 2.2L Diesel, Removal and Installation).
Refer to: Catalytic Converter - Vehicles With: Diesel Particulate Filter (DPF) (309-00B Exhaust System - TD4 2.2L Diesel, Removal and Installation).
5. WARNING: Make sure that a new nut is installed.
CAUTION: Make sure that the ball joint ball does not rotate.
- Torque: 60 Nm
- Repeat the above step for the other side.
6. WARNING: Make sure that new nuts are installed.
- Torque:
Stage 1: 175 Nm
Stage 2: 175 Nm
- Repeat the above step for the other side.
7. NOTE: Subframe shown removed for clarity.
8. Inspect the components and install new if damaged or worn.
Installation
1. To install, reverse the removal procedure.
READ NEXT:
Front Stabilizer Bar Bushing
Removal
NOTES:
Some variation in the illustrations may occur, but the essential
information is always correct.
Removal steps in this procedure may contain installation details.
1. WARNING: Make sure
Wheel Knuckle
Special Tool(s)
205-754A
Splitter, Ball Joints
205-857
Remover, Halfshaft
JLR-204-804
Lever, Wheel Knuckle
Removal
CAUTIONS:
Nuts and bolts must be tightened with the weight of the vehicle on the
sus
Front Shock Absorber Vehicles Without: Dynamic
Suspension
General Equipment
Suspension Spring Compressor
Vise
Removal
WARNINGS:
Make sure the spring compressor Safe Working Load (SWL) meets or exceeds
the spring rating quoted in the
Specifcations sectio
SEE MORE:
Audio
Front Control Module (ACM) - Low Line
Audio Front Control Module - Low Line (ACM)
CAUTION:
Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution
of control modules does
not guarantee confirmation of a fault, and may also cause additional faults in
the vehicle being tested and/or the donor
vehicle.
Bluetooth® information
Bluetooth® is the name for
short-range radio frequency (RF)
technology that allows electronic
devices to communicate wirelessly with each
other.
The Land Rover Bluetooth® system supports
Bluetooth® Hands-Free Profile (HFP),
Advanced Audio Distribution Profile (A2DP)
and Audio Video Remo
