Range Rover Evoque: Front Seat Height Adjustment Motor
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).
2. WARNING: To avoid accidental deployment, the restraints control module backup power supply must be depleted. Wait at least two minutes after disconnecting the battery ground cable(s) before commencing any repair or adjustment to the supplemental restraint system (SRS), or any component(s) adjacent to the SRS sensors.
Failure to follow these instructions may result in personal injury.
Refer to: Standard Workshop Practices (100-00 General Information, Description and Operation).
3. Refer to: Front Seat Control Switch (501-10 Seating, Removal and Installation).
4. Refer to: Front Seat (501-10 Seating, Removal and Installation).
5. CAUTION: Note the fitted position of the component prior to removal.
Vehicles with sports seats
6.
7. CAUTION: Note the fitted position of the component prior to removal.
Vehicles with heated front seats
8. NOTE: Some variation in the illustrations may occur, but the essential information is always correct.
Non NAS vehicles
9. CAUTION: Make sure that the component is aligned and attached as shown.
NAS vehicles
10.
All vehicles
11. NOTE: If equipped.
12.
13.
14. NOTE: Some variation in the illustrations may occur, but the essential information is always correct.
Torque: 28 Nm
15. Torque: 28 Nm
16. NOTES:
Use a suitable tool to remove the circlips from the seat cushion frame bolts.
Note the orientation of the components.
Right-hand shown, left-hand similar.
Repeat the procedure for the other side.
17. NOTES:
Right-hand shown, left-hand similar.
Repeat the procedure for the other side.
Torque: 20 Nm
18.
19. NOTES:
Note the orientation of the components.
Right-hand shown, left-hand similar.
20.
21. Torque: 10 Nm
Installation
1. To install, reverse the removal procedure.
READ NEXT:
Front Seat Cushion Cover
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. Prior to carrying out the step by step procedure below, Steps 2
and 3 must be followed for knowledge on
Rear Seat Cushion Cover
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Prior to carrying out the step by step procedure below, Steps 2
and 3 must be followed for knowledge on how to correc
Front Seat Backrest Heater Mat
Removal
WARNINGS:
To avoid accidental deployment and possible personal injury, the backup
power supply must be depleted before
repairing or replacing any air bag supplemental restraint system (SRS)
SEE MORE:
System difficulties
Use of an incorrect program
will impair
the vehicle's response to the terrain and
can reduce the life of the suspension
and drive systems.
If the system becomes partially inoperable for
any reason, it may not be possible to select
special programs. A warning will be given
when selection of
Wheel Knuckle Rear Bushing
Special Tool(s)
204-620-01
Installer, Wheel Knuckle Bushing
204-620-02
Remover/Installer, Wheel Knuckle Bushing
204-620-03
Remover, Wheel Knuckle Bushing
LR-121
Hydraulic Cylinder 10t
Removal
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Remove the
