Range Rover Evoque: European declaration of conformity
Hereby, DENSO CORPORATION
declares that this DN-NS-019 is in
compliance with the essential
requirements and other relevant provisions of
Directive 1999/5/EC.
READ NEXT:
Avoid exposing the fuel
gasses to any
potential sources of ignition as the
resulting fire and explosion may
cause serious injuries and/or death.
Switch off the engine when refuelling,
as it is
Do not use leaded fuels,
lead
substitutes, or fuel additives.
Fuel system cleaning agents should not
be used, unless approved by Land
Rover.
SEE MORE:
CAUTION:
Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution
of control modules does
not guarantee confirmation of a fault and may also cause additional faults in
the vehicle being checked and/or the donor
vehicle.
NOTES:
If the control module or a component
Removal
NOTES:
The back panel is manufactured from mild steel, it includes the bumper
retaining bracket.
It is necessary to remove a section of both rear lamp mounting panels to enable
removal and installation of the back panel.
1. The back panel is replaced in conjunction with:
Rear bumper cov
© 2011-2024 Copyright www.rrevoque.org