Range Rover Evoque: Direction indicator and side lamp bulbs
Removing the nearside bulbs;
To gain more room for accessibility, follow
steps 1 and 2 for moving the nearside
headlamp unit.
1. At the back of the headlamp unit, remove
the indicator bulb housing. Turn it counter
clockwise to release.
2. To remove the side lamp bulb housing.
Turn it counter clockwise to release.
Removing the offside bulbs;
To gain more room for accessibility, follow the
process for moving the offside headlamp unit.
1. At the back of the headlamp unit, remove
the indicator bulb housing. Turn it counter
clockwise to release.
2. To remove the side lamp bulb housing.
Turn it counter clockwise to release.
READ NEXT:
1. Remove the two fixings.
2. Direction indicator.
3. Reversing lamp
Turn the relevant bulb holder counter
clockwise and pull to remove from the lamp
unit. Grip the holder then press the bulb i
Access to the rear fog lamp
requires
special tools and should be undertaken
only by a qualified technician. If in
doubt, consult your Land Rover
Dealer/Authorised Repairer.
Remove any heavy deposits of
mud and
dirt with a hose before washing the
vehicle.
Never aim a hose water jet directly at
the engine air intake, heater air intakes,
body seals or at any compone
SEE MORE:
Torque Specifications
Fender
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Refer to: Front Bumper Cover (501-19 Bumpers, Removal and
Installation).
2. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
3.
4.
5.
6. Torqu
Removal
WARNINGS:
Make sure the spring compressor Safe Working Load (SWL) meets or exceeds
the spring rating quoted in the
Specifcations section.
Always follow the spring compressor manufacturer's instructions.
The spring is under extreme tension, care must be taken at all times. Failure to
foll
© 2011-2024 Copyright www.rrevoque.org