Range Rover Evoque: Body Repairs - Vehicle Specific Information and Tolerance Checks
Body
and Frame
Front End Body Dimensions
NOTES:
All dimensions shown are in millimetres (mm).
Dimensions shown to holes, are always taken from/to the hole centre. They are
also always to the body panel
surface, not to the top of bolts or components.
Side Panel Dimensions
3-door version
5-door version
3-door version
5-door version
Rear End Body Dimensions
Under Body Dimensions
Gap and Profile measurements
The following information is to be used as a guide to assist the technician
in installing exterior body panels and trim items
so as to achieve a correctly aligned and cosmetically acceptable vehicle.
NOTE: All dimensions shown are in millimetres (mm).
READ NEXT:
Removal
NOTE: The front bumper mounting is manufactured from HSLA300 and mild
steel.
1. In this procedure, to make sure the vehicle is correctly aligned, it must
be placed on
an approved alignment j
Removal
NOTES:
The front side member is manufactured from RP260 and DP600.
The front side member long section is cut from the front side member and is
manufactured from RP260.
The service panel is
SEE MORE:
Component Location
Stabilizer link
RH (right-hand) spring and damper assembly
Stabilizer bar
LH (left-hand) spring and damper assembly
Wheel knuckle
Stub axle and locknut
Hub
Longitudinal link
Rear transverse link
Front transverse link
Front Wheel Drive (FWD) Rear Subframe
Overview
The
Tyre information label location.
Tyre pressures should be
checked
regularly using an accurate pressure
gauge, when the tyres are cold.
The following procedure should be used to
check and adjust the tyres pressures.
1. Remove the valve cap.
2. Firmly attach a tyre pressure gauge/inflator
© 2011-2024 Copyright www.rrevoque.org