Range Rover Evoque: Airbag deployment effects
When an airbag inflates, a
fine
powder is released. This is normal
and not an indication of a malfunction.
The powder may cause irritation to the
skin and should be thoroughly flushed
from eyes and any cuts or abrasions. If
breathing difficulty is experienced,
leave the vehicle if possible or open
the windows or doors to allow fresh air
in.
Airbags inflate at high speed and can
cause injuries. To minimise the risk of
injury, ensure that all occupants wear
correctly positioned seat belts, sit
correctly in the seats and position the
seats as far back as is practicable.
Airbag deployment is accompanied by
a very loud noise which may cause
discomfort and temporary loss of
hearing.
After inflation, some airbag
components will be very hot. Do not
touch the airbag components until
they have cooled sufficiently.
READ NEXT:
Airbag warning lamp
Airbag warning lamp
The airbag warning lamp is
mounted in the instrument pack
and will illuminate as a bulb check
when the ignition is turned on.
If the warning lamp indicates
that a
fault
Airbag service information
Do not attempt to service,
repair,
replace, modify, or tamper with, any
part of the SRS. This includes wiring
or components in the vicinity of SRS
components. Doing so may cause the
system to
Disability modifications
Occupants with disabilities which may require
modification of the vehicle, must contact a
Dealer/Authorised Repairer before any
modifications are made.
SEE MORE:
Lower Arm
Removal
CAUTION: Nuts and bolts must be tightened with the weight of the vehicle
on the suspension.
NOTES:
RH illustration shown, LH is similar.
Removal steps in this procedure may contain installation details.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the ve
Front Seat Backrest Cover
Removal
WARNINGS:
To avoid accidental deployment and possible personal injury, the backup
power supply must be depleted before
repairing or replacing any air bag supplemental restraint system (SRS)
components. To deplete the backup power supply
energy, disconnect the battery ground cable and wait
